Skip to content
Pedalatry

MXR · Modulation

Flanger

18V · 39 mA · maker

Flanger, 127 by 95 mm
Buy at SweetwaterFind it used on Reverb

MXR Flanger power requirements

  • 18V DC · polarity not stated · draws 39mA

    also runs on a 9V battery · from the maker

    “The MXR Flanger is powered by two 9-volt batteries (remove bottom plate to install), an 18-volt AC adapter such as the Dunlop ECB004/ECB004E, or a DC Brick™ power supply. … Current Draw 39 mA … Power Supply 18 volts DC” source

    Checked 2026-10-13

Size

127 × 95 × 45 mm (5.00 × 3.74 × 1.77 in)

Width × depth × height, from the retailer listing.

Power supplies that can run it

Each has an output that can power it, checked against its published figure. Plan the whole board to see what runs everything.

  • Walrus Audio Canvas Power 1515 outputs · isolatedSweetwater
  • Rockboard ISO Power Block V1615 outputs · isolatedSweetwater
  • Fender Engine Room LVL1212 outputs · isolatedSweetwater
  • Rockboard ISO Power Block V12 IEC12 outputs · isolatedSweetwater
  • Truetone 1 SPOT Pro CS1111 outputs · isolatedSweetwater
  • Truetone 1 SPOT Pro CS1212 outputs · isolatedSweetwater

Plan a board with it

Affiliate disclosure: some links to retailers are affiliate links. If you buy through one we may earn a commission, at no extra cost to you. It never changes what we show you.

Pedalatry is independent and not affiliated with, or endorsed by, any manufacturer or retailer. Product names are trademarks of their owners, used only to identify their products.

© 2026 PedalatryAboutFor makersPrivacyTermsContact

Setting up the stage…